1/19/2024 0 Comments Parsec echo cancellationThis can be located on various locations depending on your driver/OS combination, you will have to look for this. Make sure the microphone is the only entry that is being recorded from. From windows users we have often heard you can select from which devices to record in the mixer (a mixer is the place where you can slide all these volume controls). They should be configurable by your driver too (its not a bug, its a feature). These echoes are produced by your sound-drivers. Try and keep your microphone as far away as possible from the headset (or generally speaking, the sound-source).Use headphones that shield well, meaning they prevent as much sound as possible from being audible to the outside.Switch your speakers off when TeamSpeak is on and use a headset to hear.This type of echo is nearly impossible to fix completely, but you can minimize it greatly if you follow a few general points: If you are not, it's the first issue, if you are still echoing you have the second issue. Just turn your speakers/headsets off (volume = 0%), and ask your friends if you are still echoing. You can find out which issue this is quite easily. Your sound driver is recording all the sound that you hear for you.The sound from your speakers/headphones is being recorded by your microphone.Here's an example of the old config.txt format: host_virtual_monitors=2Īnd here's an example of the new config. The config.json file can be found in the same location as config.txt (see the folder paths further at the start of this page for more information). Similarly to config.txt, it'll be necessary to save the file and restart Parsec, for the changes to apply. You can make sure the JSON is valid by copying the config.json file (or the characters inside) to jsonlint. If you modify the config.json file, your modifications must be valid JSON otherwise the file will be reset. The settings in the config.txt file will be cleared once the settings have been saved and migrated. Keep in mind that the configurations are only moved if the file is correctly saved and Parsec is restarted, as usual. You can still add your configuration options to config.txt, and Parsec will move them to config.json, for backwards compatibility. This new configuration file exists in the same location as config.txt. Starting in Parsec version 150-89, Parsec will move any advanced configurations from config.txt to config.json. You can see a list of the available configuration options here.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |